BOHNING NOCK SIGNATURE AP
Pack of 100 pieces
BOHNING NOCK SIGNATURE LM
Pack of 100 pieces
BOHNING NOCK SIGNATURE RS
Pack of 100 pieces
BOHNING NOCK SIGNATURE BK
Pack of 100 pieces
Bohning’s Signature® Nock fits standard carbon shafts with an ID of .246″ (commonly known as 6.5mm or S Nock) and Super UNI Bushing systems. The Signature® Nock features a smooth throat and a raised index. Its throat size is .109″ (2.77mm) and each Signature® Nock weighs an average of 12.0 grains (777.6 mg).
Tech tip: for easier insertion and indexing, apply a small amount of Bohning’s Tex-Tite or Seal-Tite Wax to the nock shank.
NOT ALL BRANDS OF NOCKS ARE CREATED EQUAL
At Bohning, every nock style must pass the following steps before introduction to the market:
1. Computer simulations identify potential weak points.
2. Destructive testing methods expose possible design flaws or material defects.
3. Accelerated life cycle testing using a custom-built bow is performed at kinetic energy levels exceeding 110 ft-lbs (nearly twice that of most hunting bows). A single nock must withstand over 1000 shots or it goes back to step 1.
Proudly manufactured at the Bohning Factory in Lake City, Michigan, United States.
Pack of 100 pieces
16 other products in the same category:
Nock 2312/2, Red #10
Kategorie: In-Nocken #2
Insert nocks for internal diameter 5.2 mm.
Available in different colours.
Weight: 8.7 grains Pack of 12 pieces
The Beiter Plug-in Nocks were originally developed for use as Nocks that are plugged directly into the aluminium shafts (instead of on the cone or...
Insert nocks for an inner diameter of 4.2mm (.165"), available in Small with a nock seat size of 0.088" and Large with a nock seat size of 0.098"....
Bohning’s Blazer® Nock fits standard carbon shafts with an ID of .246″ (6.25mm, but commonly known as 6.5mm) and Super UNI Bushing systems. The...
Symmetric nocks, which can be used on every Easton and Beman shaft equipped with this system. They are ideal if you use a loop on the string....
A new system for the positioning of an arrow on your bow. The ThunderBall system is mounted within a few minutes and eliminates any torsion problem...
Features:
Precise contact points for controlled arrow release.
Concentric design to center the nock in the arrow shaft for more consistent...
Insert nocks for shafts with 6.2mm inside diameter. Known also as -60 or Super UNI.
Profile particularly appreciated by 3D shooters.
Available in...
Nock 3-18/2,
Colour: Green
Kategorie: In-Nocken #2
Nock suitable for Cross-X Fulmen shafts and all shafts with an internal diameter of .244.
