Uni Bushing Cam from Bohning are suitable for shafts with inner diameter .166" (00-er - Uni Bushing). This cam is provided with dual click and a marking.
It is recommended to apply some Bohning Tex-Tite or Seal-Tite wax to the end of the cam before fitting the cam and insert the cam into the shaft rotating.
NOT ALL BRANDS WORK THE SAME
At Bohning, all cams must pass the following tests before they are released to the market:
1. computer simulation to identify any weak points.
2. fracture tests which would reveal projection errors or material defects.
3. stress and wear tests using a specially designed bow that subjects the nock to kinetic energy exceeding 110 ft-lbs (almost twice that of most hunting bows). Each individual nock must withstand 1,000 shots.
Pack of 100 pieces
Insert nocks for an inner diameter of 4.2mm (.165"), available in Small with a nock seat size of 0.088" and Large with a nock seat size of 0.098"....
16 other products in the same category:
In-Out nocks are designed to enter inside A.C.E. or X10 shafts. At the same time they cover the external side of the shaft itself in order to...
A new system for the positioning of an arrow on your bow. The ThunderBall system is mounted within a few minutes and eliminates any torsion problem...
Insert nocks for internal diameter 5.2 mm.
Available in different colours.
Weight: 8.7 grains Pack of 12 pieces
Insert nock with internal diameter of 4.5 mm suitable for arrows called -04 or for the Carbon Express Medallion®.
Available in color: fluo green,...
Features:
Precise contact points for controlled arrow release.
Concentric design to center the nock in the arrow shaft for more consistent...
Features:
Precise contact points for controlled arrow release.
Concentric design to center the nock in the arrow shaft for more consistent...
In-Out nocks are designed to enter inside A.C.E. or X10 shafts. At the same time they cover the external side of the shaft itself in order to...
The short, lightweight design of this cam offers maximum speed, precision and durability.
Only suitable for use with D-Loop!
Available in the...
Nock 3-18/2,
Colour: Green
Kategorie: In-Nocken #2
Insert nocks for shafts with 6.2mm inside diameter. Known also as -60 or Super UNI.
Profile particularly appreciated by 3D shooters.
Available in...
Insert nocks for shafts with 6.2mm inside diameter. Known also as -60 or Super UNI.
Available in the following colors: fluo yellow, fluo red, fluo...
Insert nocks for an inner diameter of 4.2mm (.165"), available in Small with a nock seat size of 0.088" and Large with a nock seat size of 0.098"....
Nock suitable for Cross-X Fulmen shafts and all shafts with an internal diameter of .244.
